Have my doubts

DonVoigt · 07-29-2015, 10:33 PM

The original breeching washer I bought from Tom Heller, for installing a "long" threaded barrel into a short frame, measures 2.60 mm or 0.101".

It is reportedly an original washer: I can't imagine they would leave it that much longer than required.

Tom?

I was not able to try it out, as my "long" threaded barrel would not turn into the receiver I was trying. I need one of those thread chasers!

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

07-29-2015, 10:33 PM	#13
DonVoigt User Join Date: Apr 2015 Location: near Charlotte NC Posts: 4,681 Thanks: 1,443 Thanked 4,356 Times in 2,041 Posts	The original breeching washer I bought from Tom Heller, for installing a "long" threaded barrel into a short frame, measures 2.60 mm or 0.101". It is reportedly an original washer: I can't imagine they would leave it that much longer than required. Tom? I was not able to try it out, as my "long" threaded barrel would not turn into the receiver I was trying. I need one of those thread chasers!