Mec-Gar Mag Compatibility Problem

leahmatt · 07-06-2014, 02:13 AM

Thanks for both your replies.

Mag catch seems okay.

I marked where the top of Mec-Gar mag reached in the upper part of the mag well, and that line was .04-.05 inches above where the Mauser mag was.

So, I took a diamond-pointed Dremel engraving tool under a lower power microscope and adjusted the mag catch hole so that the reach of the Mauser mag and the Mec-Gar are now the same.

I'll take it to the range tomorrow and see if this helps.

Thanks

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

07-06-2014, 02:13 AM	#4
leahmatt User Join Date: Sep 2013 Posts: 6 Thanks: 6 Thanked 0 Times in 0 Posts	Thanks for both your replies. Mag catch seems okay. I marked where the top of Mec-Gar mag reached in the upper part of the mag well, and that line was .04-.05 inches above where the Mauser mag was. So, I took a diamond-pointed Dremel engraving tool under a lower power microscope and adjusted the mag catch hole so that the reach of the Mauser mag and the Mec-Gar are now the same. I'll take it to the range tomorrow and see if this helps. Thanks