Is this Navy Correct?

Ben M. · 03-09-2014, 10:03 PM

hard to see, but the groove where the old gesichert was milled out is normally not blued but bare white metal that begins to rust. if blued in the groove, then maybe a refinish was done on the gun.

gunbugs · 03-11-2014, 12:57 AM

Some 06's, like mine, had the lower safety marking "scrubbed", instead of milled.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

03-09-2014, 10:03 PM	#1
Ben M. User Join Date: Dec 2009 Location: Retired to Naples, FL. Posts: 499 Thanks: 96 Thanked 146 Times in 91 Posts	hard to see, but the groove where the old gesichert was milled out is normally not blued but bare white metal that begins to rust. if blued in the groove, then maybe a refinish was done on the gun.

03-11-2014, 12:57 AM	#2
gunbugs Lifetime Forum Patron Join Date: Sep 2013 Location: Fairbanks, Alaska. Home of the best moose. Posts: 672 Thanks: 371 Thanked 1,202 Times in 407 Posts	Some 06's, like mine, had the lower safety marking "scrubbed", instead of milled.