How to ream a #2 Morse taper

Olle · 04-27-2013, 10:09 PM

Thanks for the tips, I have already bid on what I think is a good, US made reamer on eBay so I hope I can get going pretty soon. I don't think it will be too bad, my only major concern is the material. Setting a file to it should give me a good indication of how hard it is. I'll probably get back with more questions before I start, I usually want to cross the t's and dot the i's over and over ad nauseam every time I'm fixin' to ruin something expensive.

I really won't have much use for the reamer once I'm done, so if you have time to wait I'll just send it to you. I might even send it to you when I get it, so you can try first.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

04-27-2013, 10:09 PM	#3
Olle User Join Date: Feb 2010 Location: Tennessee Posts: 1,149 Thanks: 159 Thanked 664 Times in 318 Posts	Thanks for the tips, I have already bid on what I think is a good, US made reamer on eBay so I hope I can get going pretty soon. I don't think it will be too bad, my only major concern is the material. Setting a file to it should give me a good indication of how hard it is. I'll probably get back with more questions before I start, I usually want to cross the t's and dot the i's over and over ad nauseam every time I'm fixin' to ruin something expensive. I really won't have much use for the reamer once I'm done, so if you have time to wait I'll just send it to you. I might even send it to you when I get it, so you can try first.