upload photo | donate | calendar
|
my profile |
register |
faq |
search upload photo | donate | calendar |
04-25-2013, 09:34 AM
|
#4 |
|
Twice a Lifer
Lifetime Forum Patron 
Join Date: Mar 2011
Location: Atop the highest hill in Schuyler County NY
Posts: 3,374
Thanks: 7,447
Thanked 2,613 Times in 1,380 Posts
|
Olle,
The hole may be too large for an original pin to stay in place. A handy way to come up with impromptu small pins that are slightly oversize is to check an index of numbered drill bits for a shank that will fit better. The bits of the numbered format vary in diameter by steps of as little as .001". Proper heat treating may ultimately be in order, but this would be a good start.
__________________
"... Liberty is the seed and soil, the air and light, the dew and rain of progress, love and joy."-- Robert Greene Ingersoll 1894 |
|
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode