upload photo | donate | calendar
|
my profile |
register |
faq |
search upload photo | donate | calendar |
03-25-2013, 03:34 PM
|
#4 |
|
Super Moderator - Patron
LugerForum Life Patron 
Join Date: Dec 2009
Location: Eastern North Carolina, USA
Posts: 3,925
Thanks: 1,377
Thanked 3,139 Times in 1,520 Posts
|
Hi,
The hole in the 682m was done after it left the factory, and I think it detracts from it. It might be possible to fix that using a TIG welder, and some work to re-contour the area and refinish it, but it would cost more than the work is worth. Both were early (1923-1924) commercial Lugers exported to the USA. Double check to ensure that one is in 9mm. That would be unusual. Marc
__________________
 Igitur si vis pacem, para bellum -- Therefore if you want peace, prepare for war. |
|
|
| The following member says Thank You to mrerick for your post: |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode