Breech Block issues

luscioman · 12-22-2010, 01:04 AM

One of the guns I purchased was broken when I got it so I never added to the issue. The other two guns I did shoot. One of which I shot approx 100-200 rounds while i solved the sight issue with it. I also work at an ammunition manufacture and I have only used 115gr standard load ammunition on it. I will try to get some pictures of the other ones as well to post up. The one shown was my arty that I got 2 years ago. I have to make a correction. I have another shooter that I have probably shot 2k rounds through that has does not have this issue.

LugerVern · 12-22-2010, 06:54 AM

Weak main springs can cause this issue, the breach block can actually hit the rear of the frame in this case.

The best way would be to have a spot weld applied and then shaped.

I have tried various fillers and glues over the years and even though some held up for a while the best way I know of is to use the spot weld repair.

Good luck

Vern

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

12-22-2010, 01:04 AM	#1
luscioman User Join Date: Feb 2005 Location: Miami, FL Posts: 113 Thanks: 1 Thanked 1 Time in 1 Post	One of the guns I purchased was broken when I got it so I never added to the issue. The other two guns I did shoot. One of which I shot approx 100-200 rounds while i solved the sight issue with it. I also work at an ammunition manufacture and I have only used 115gr standard load ammunition on it. I will try to get some pictures of the other ones as well to post up. The one shown was my arty that I got 2 years ago. I have to make a correction. I have another shooter that I have probably shot 2k rounds through that has does not have this issue.

12-22-2010, 06:54 AM	#2
LugerVern User Join Date: Apr 2005 Location: Virginia Posts: 563 Thanks: 1 Thanked 34 Times in 27 Posts	Weak main springs can cause this issue, the breach block can actually hit the rear of the frame in this case. The best way would be to have a spot weld applied and then shaped. I have tried various fillers and glues over the years and even though some held up for a while the best way I know of is to use the spot weld repair. Good luck Vern