new luger dont fire

mrerick · 08-24-2010, 07:19 PM

Hi ,

You should be able to see the firing pin protruding from a small hole in the middle of the forward face of the breech block.

It's possible that it's broken, but it could also be quite dirty in there. You'll have to disassemble your Luger to check on it.

There are instructions here: http://lugerforum.com/lugerparts.html

Be sure that the gun is unloaded, and that you check the chamber before you disassemble it. A loaded luger can easily fire when it's disassembled.

Your gun may need cleaning and lubrication most. The Luger is a very tight tolerance firearm, and just a little dirt can get in the way...

Marc

08-24-2010, 07:19 PM	#2
mrerick Super Moderator - Patron LugerForum Life Patron Join Date: Dec 2009 Location: Eastern North Carolina, USA Posts: 3,920 Thanks: 1,377 Thanked 3,135 Times in 1,518 Posts	Hi , You should be able to see the firing pin protruding from a small hole in the middle of the forward face of the breech block. It's possible that it's broken, but it could also be quite dirty in there. You'll have to disassemble your Luger to check on it. There are instructions here: http://lugerforum.com/lugerparts.html Be sure that the gun is unloaded, and that you check the chamber before you disassemble it. A loaded luger can easily fire when it's disassembled. Your gun may need cleaning and lubrication most. The Luger is a very tight tolerance firearm, and just a little dirt can get in the way... Marc __________________ Igitur si vis pacem, para bellum - - Therefore if you want peace, prepare for war.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode