action stuck open

Ice · 05-14-2009, 08:13 AM

You might try removing the magazine and pulling the toggle back and looking to see if the holdopen is still sticking up. Could be that its stuck because of a bur or dried grease in the little slot.

Charlie

humboldtdan · 05-14-2009, 11:11 AM

I have removed mag and pulled back. is it possible to disassemble with toggle back? Sorry, I found the gun in this condition among my deceased fathers things, and am not that familiar with the luger, but have been looking at disassembly and it seems like the toggle needs to be forward for disassembly.
THANKS!

G.T. · 05-14-2009, 12:21 PM

CAREFULLY remove the right grip panel.......you can see alot with the grips removed, and also access the holdopen...good luck...til..lat'r...GT

sheepherder · 05-14-2009, 12:31 PM

I'd try pushing down on the part shown in the first pic...while holding back on the toggle...(it will bite you)...

Second pic shows the holdopen in released position...

05-14-2009, 12:21 PM	#3
G.T. Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: Chandler Arizona Posts: 3,541 Thanks: 1,342 Thanked 3,743 Times in 1,020 Posts	take the grips off! CAREFULLY remove the right grip panel.......you can see alot with the grips removed, and also access the holdopen...good luck...til..lat'r...GT

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

05-14-2009, 08:13 AM	#1
Ice User Join Date: Mar 2009 Location: Texas Posts: 552 Thanks: 13 Thanked 69 Times in 57 Posts	You might try removing the magazine and pulling the toggle back and looking to see if the holdopen is still sticking up. Could be that its stuck because of a bur or dried grease in the little slot. Charlie

05-14-2009, 11:11 AM	#2
humboldtdan User Join Date: May 2009 Posts: 6 Thanks: 0 Thanked 0 Times in 0 Posts	I have removed mag and pulled back. is it possible to disassemble with toggle back? Sorry, I found the gun in this condition among my deceased fathers things, and am not that familiar with the luger, but have been looking at disassembly and it seems like the toggle needs to be forward for disassembly. THANKS!