How to dissemble Browning FN 1900

Stevie · 03-06-2009, 12:56 PM

Remove mag and ensure the pistol is empty. Un-**** the striker, remove the screws mentioned, slide should come off forward from the breech assembly.

May be a tight fit. Might have to bump the slide forward a bit with a soft hammer, it won't just pop apart.

The grips have retaining plates inside to keep the grips attached, just loosen the screws and rotate the plates to remove the grips.

Not all that much to a FN Browning 1900, but it is hard to see the Browning influence alongside other Browning designed pistols.

What? uncocked must be a bad word.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

03-06-2009, 12:56 PM	#7
Stevie User Join Date: Aug 2002 Location: Ok. Posts: 212 Thanks: 0 Thanked 0 Times in 0 Posts	Remove mag and ensure the pistol is empty. Un-**** the striker, remove the screws mentioned, slide should come off forward from the breech assembly. May be a tight fit. Might have to bump the slide forward a bit with a soft hammer, it won't just pop apart. The grips have retaining plates inside to keep the grips attached, just loosen the screws and rotate the plates to remove the grips. Not all that much to a FN Browning 1900, but it is hard to see the Browning influence alongside other Browning designed pistols. What? uncocked must be a bad word.