upload photo | donate | calendar
|
my profile |
register |
faq |
search upload photo | donate | calendar |
|
|
02-17-2009, 06:29 PM
|
#1 |
|
Lifer
Lifetime Forum Patron 
Join Date: Feb 2009
Location: ...on the 'ol Erie Canal...
Posts: 8,208
Thanks: 1,425
Thanked 4,474 Times in 2,343 Posts
|
Got some work done on the rear sight base today...Cut the reverse dovetails; made sure it would be a tight fit; and hogged out the sight cavity...
|
|
|
|
02-17-2009, 06:35 PM
|
#2 |
|
Lifer
Lifetime Forum Patron
Join Date: Feb 2009
Location: ...on the 'ol Erie Canal...
Posts: 8,208
Thanks: 1,425
Thanked 4,474 Times in 2,343 Posts
|
...and cut the slot for the C96 Mauser rear sight axle with a keyway cutter...Fits real good!
 Need to locate the axle pivot holes and then mill the "slope" for the slider...I was thinking of shortening the C96 sight, but I think I'll leave it as is...If I have to, I'll mill a crescent in the bottom of the leaf to fit snug over the receiver (instead of notching the receiver)...  Heh...A 1000 meter Luger sight... 
|
|
|
|
|
02-18-2009, 05:09 PM
|
#3 |
|
Lifer
Lifetime Forum Patron
Join Date: Feb 2009
Location: ...on the 'ol Erie Canal...
Posts: 8,208
Thanks: 1,425
Thanked 4,474 Times in 2,343 Posts
|
Got the rear sight base fit today; also fit the C96 rear sight to it...
Not too bad...I think I can guarantee some fistfights at the next ESACA gun show...
|
|
|
|
 |
| Tags |
| blivet |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
