Sear bar? Cant get it out....

Ron Wood · 06-20-2007, 04:31 PM

Without pictures, it sounds like you are talking about the sear bar spring. It needs to be removed to take out the sear bar. Lift up on the front of the spring by inserting a small screwdriver under the curved forward end. Push the spring forward and it will slide out of the frame. The sear bar can then be lifted out of the frame.
To re-assemble, put the sear bar back in the frame, place the spring on top of the bar and press down and back to slide the spring back into the groove in the frame.

06-20-2007, 04:31 PM	#2
Ron Wood Moderator 2010 LugerForum Patron Join Date: Jun 2002 Location: Santa Teresa New Mexico just outside of the West Texas town of El Paso Posts: 7,040 Thanks: 1,106 Thanked 5,257 Times in 1,724 Posts	Without pictures, it sounds like you are talking about the sear bar spring. It needs to be removed to take out the sear bar. Lift up on the front of the spring by inserting a small screwdriver under the curved forward end. Push the spring forward and it will slide out of the frame. The sear bar can then be lifted out of the frame. To re-assemble, put the sear bar back in the frame, place the spring on top of the bar and press down and back to slide the spring back into the groove in the frame. __________________ If it's made after 1918...it's a reproduction

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode