LugerForum Discussion Forums my profile | register | faq | search
upload photo | donate | calendar

Go Back   LugerForum Discussion Forums > General Discussion Forums > Shooting and Reloading

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Unread 06-14-2020, 04:29 PM   #2
mrerick
Super Moderator - Patron
LugerForum
Life Patron
 
mrerick's Avatar
 
Join Date: Dec 2009
Location: Eastern North Carolina, USA
Posts: 3,920
Thanks: 1,377
Thanked 3,135 Times in 1,518 Posts
Default

Note that the OAL listed for cartridges in reloading guides are for specific bullets (and bullet profiles).

You can't use the same OAL for a round nose bullet as you would for a flat nose one. It will result in the bullet being seated too shallowly in the case, and this can seriously change the ballistics at time of ignition, the jump into the leade and the engagement hesitation delay. This can then change the peak pressure(s) considerably from what was found experimentally in the manual.

Your 9mm Luger round looks seated far shallow into the case. The bullet should never be actually in contact with the leade while chambered. It needs the "jump" across an air gap to gain adequate acceleration prior to the resistance of leade engagement and hesitation as it starts traveling in the rifling.

What reloading manual are you using, and which cartridge / bullet / powder / primer combination?
__________________
Igitur si vis pacem, para bellum -
- Therefore if you want peace, prepare for war.
mrerick is offline   Reply With Quote
The following member says Thank You to mrerick for your post:
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 03:11 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright © 1998 - 2025, Lugerforum.com