New Luger. Can someone help tell me what I found?

lugerholsterrepair · 12-26-2018, 04:44 PM

Don is likely more right than I am. It is actually very difficult to "drive" in a pin this small. Yes, it must be fairly tight so as not to fly out but a matter of semantics. A lot of small pins on Luger pistols are push in push out. " I am a metal worker and have a metal working shop in my garage." I actually went to gunsmithing school in the early 70's. One has to be careful in any choice of words on how to explain but since you are a metal worker you know. I think my main concern is that a non metal worker did not go about trying to Drive in an oversized mashed up pin!

12-26-2018, 04:44 PM	#22
lugerholsterrepair Moderator Lifetime Forum Patron Join Date: Jun 2002 Location: Arizona/Colorado Posts: 7,775 Thanks: 4,995 Thanked 3,134 Times in 1,439 Posts	Don is likely more right than I am. It is actually very difficult to "drive" in a pin this small. Yes, it must be fairly tight so as not to fly out but a matter of semantics. A lot of small pins on Luger pistols are push in push out. " I am a metal worker and have a metal working shop in my garage." I actually went to gunsmithing school in the early 70's. One has to be careful in any choice of words on how to explain but since you are a metal worker you know. I think my main concern is that a non metal worker did not go about trying to Drive in an oversized mashed up pin! __________________ Jerry Burney 11491 S. Guadalupe Drive Yuma AZ 85367-6182 lugerholsterrepair@earthlink.net 928 342-7583 (CO & AZ) Year Round 719 207-3331 (cell) "For those who Fight For It, Life has a flavor the protected will never know."