Front sight issues- too low

alanint · 08-17-2013, 07:16 AM

As a parts gun, there may not be a notch in your receiver under The rear sight. If that is The case, your rear sight may be sitting too high, which would produce precisely that high point of impact. Your front sight is normal, so I would look at the rear sight first, followed by whether the barrel was properly installed.
Send a photo of the area under the rear sight where The barrel meets The upper receiver.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

08-17-2013, 07:16 AM	#4
alanint User Join Date: Mar 2008 Location: Marco Island, Florida Posts: 4,867 Thanks: 1,685 Thanked 1,917 Times in 1,193 Posts	As a parts gun, there may not be a notch in your receiver under The rear sight. If that is The case, your rear sight may be sitting too high, which would produce precisely that high point of impact. Your front sight is normal, so I would look at the rear sight first, followed by whether the barrel was properly installed. Send a photo of the area under the rear sight where The barrel meets The upper receiver.