1900 luger firing pin

Karl · 10-02-2012, 09:43 AM

Rich,
This would be so much easier if we could swap out firing pins face to face, however, I am unclear on the situation: Your initial post stated that you wanted the FP tip repaired but judging from your photo the tip appears intact. You also stated that the FP does protrude from the breech block, suggesting again that the tip is intact. How far does the tip protrude? Have you test fired a primed case? Is there damage to the FP tip that is not evident in the photo? As a reference my 1900 FP projects about .050" from breech block.
KFS

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

10-02-2012, 09:43 AM	#14
Karl Lifer - Twice Over Lifetime Forum Patron Join Date: Jun 2002 Location: Savannah Posts: 530 Thanks: 0 Thanked 280 Times in 123 Posts	Rich, This would be so much easier if we could swap out firing pins face to face, however, I am unclear on the situation: Your initial post stated that you wanted the FP tip repaired but judging from your photo the tip appears intact. You also stated that the FP does protrude from the breech block, suggesting again that the tip is intact. How far does the tip protrude? Have you test fired a primed case? Is there damage to the FP tip that is not evident in the photo? As a reference my 1900 FP projects about .050" from breech block. KFS