I.D. tool marked 7above & U below hole

dalep38 · 03-12-2008, 09:58 PM

Gentlemen : I have a Luger tool that seems proper Thickness which would be under 1/10 of an inch and the marks are 7 above hole and U below the hole ,no other marks present . I have been looking in several books and can't find the clue to the Luger it is for, unless this is some type of unit marking or something like that for a commercial Luger used by some group maybe? Any help would be greatly appreciated. I will post pictures if interest warrants it. Thank You, Dale

03-12-2008, 09:58 PM	#1
dalep38 Lifer Lifetime Forum Patron Join Date: Feb 2008 Location: Southeast USA Posts: 60 Thanks: 5 Thanked 3 Times in 2 Posts	I.D. tool marked 7above & U below hole Gentlemen : I have a Luger tool that seems proper Thickness which would be under 1/10 of an inch and the marks are 7 above hole and U below the hole ,no other marks present . I have been looking in several books and can't find the clue to the Luger it is for, unless this is some type of unit marking or something like that for a commercial Luger used by some group maybe? Any help would be greatly appreciated. I will post pictures if interest warrants it. Thank You, Dale __________________ Always looking for early P.38's Original finish collector grade ,Zeros,480,ac only,40 added,ac40,ac41's and mags

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode