Black Widow grip observation

Pete Ebbink · 12-28-2006, 01:07 PM

Just 2 possiblities about the little "O" 's :

1. Air bubbles that came to the surface while the resin was setting up.

2. The maker used a 2-pronged tool to test the resin to make sure it was hard enough to pull the grip out of the mold ? Maybe the left and right grip were poured in a common mold so only 1 of the 2 grips needed to be tested with the pronged testing tool.

3. Any other ideas ??????

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

12-28-2006, 01:07 PM	#10
Pete Ebbink User Join Date: Jun 2002 Location: The USA Posts: 5,919 Thanks: 0 Thanked 7 Times in 5 Posts	Just 2 possiblities about the little "O" 's : 1. Air bubbles that came to the surface while the resin was setting up. 2. The maker used a 2-pronged tool to test the resin to make sure it was hard enough to pull the grip out of the mold ? Maybe the left and right grip were poured in a common mold so only 1 of the 2 grips needed to be tested with the pronged testing tool. 3. Any other ideas ??????