Not ejecting

Steve · 02-18-2002, 09:29 PM

I want to make sure I am undertanding something correctly. If a Luger is not ejecting the empty brass and the problem goes away with hotter loads, will cutting a loop off of the recoil spring help a weaker load to cycle? I am getting close to the maximum load and the problem is almost gone. I would prefer to use a weaker load and save wear and tear on the gun.

Lonnie Zimmerman · 02-18-2002, 10:43 PM

Steve; you can buy a new weaker spring from Wolff. What load do you use that you believe is getting close to max?

Lonnie

Spencer · 02-19-2002, 05:37 PM

At the range today I found the same problem with 115 gr. FMJ but no problems with 124 gr. FMJ from the same manufacturer. I have a 1939 S/42.

02-18-2002, 09:29 PM	#1
Steve User Join Date: Sep 2002 Location: Ohio Posts: 200 Thanks: 0 Thanked 0 Times in 0 Posts	Not ejecting I want to make sure I am undertanding something correctly. If a Luger is not ejecting the empty brass and the problem goes away with hotter loads, will cutting a loop off of the recoil spring help a weaker load to cycle? I am getting close to the maximum load and the problem is almost gone. I would prefer to use a weaker load and save wear and tear on the gun.

02-18-2002, 10:43 PM	#2
Lonnie Zimmerman User Join Date: Jun 2002 Posts: 523 Thanks: 0 Thanked 1 Time in 1 Post	Re: Not ejecting Steve; you can buy a new weaker spring from Wolff. What load do you use that you believe is getting close to max? Lonnie

02-19-2002, 05:37 PM	#3
Spencer User Join Date: Jun 2002 Posts: 26 Thanks: 0 Thanked 0 Times in 0 Posts	Re: Not ejecting At the range today I found the same problem with 115 gr. FMJ but no problems with 124 gr. FMJ from the same manufacturer. I have a 1939 S/42.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode