Thread: Tight Pin
View Single Post
Unread 07-04-2011, 10:35 AM   #13
Lugerdoc
Patron
LugerForum
Patron
 
Lugerdoc's Avatar
 
Join Date: Jun 2002
Location: POB 398 St.Charles,MO. 63302
Posts: 5,089
Thanks: 6
Thanked 737 Times in 484 Posts
Default

Jack, Your mid toggle link, may not be numered inside. The "OZ" that you mentioned on the left side is probably actually a crown/N test fire proof. The number on the rear of an Alpha commerical breech block is NOT a serial #, so these 2 digits will not match your serial, althought the last 2 digit on the inside of your extractor should match the serial #. I have seen some forward axels actually break in half inside, making them difficult to remove; Best done with a high pressure press. TH
__________________
Tom Heller POB 398 ST.Charles, MO. 63302
Tel 636-447-3006 lugerdoc@charter.net
Lugerdoc is offline   Reply With Quote
The following member says Thank You to Lugerdoc for your post: