LugerForum Discussion Forums - View Single Post

Ron Smith · 01-08-2009, 04:32 PM

Hi Alan,

The simple way to do it is:

With the toggle down and in battery. Place the muzzle against a rigid non-marring surface, push firmly.

The receiver will slide back approx.1/4" to 3/8" and stop. Hold it there and install the side plate rear end fist, then pivot the take down lever up into place.

Gently relieve the pressure and let the receiver slide forward.

Everything should be correct. If not, repeat the prodedure.

Ron

01-08-2009, 04:32 PM	#2
Ron Smith User Join Date: Feb 2004 Location: Orygun Posts: 4,243 Thanks: 118 Thanked 245 Times in 150 Posts	Hi Alan, The simple way to do it is: With the toggle down and in battery. Place the muzzle against a rigid non-marring surface, push firmly. The receiver will slide back approx.1/4" to 3/8" and stop. Hold it there and install the side plate rear end fist, then pivot the take down lever up into place. Gently relieve the pressure and let the receiver slide forward. Everything should be correct. If not, repeat the prodedure. Ron __________________ I Still Need DWM side plate #49... if anyone runs across a nice one. What ~Rudyard Kipling~ said...