Broken Toggle Pin Retainer Pin
 

The "retainer" pin which holds the center toggle pin has broken off at the base, leaving me with a blind hole blocked by the base of that retainer pin. Is this common? Is there a recommended way to get it out? Is there somebody who can repair this? This is my first post. Thanks in advance for any advice

Contact GT on this forum (gctomeks@msn.com) Bill

middle toggle pin retaining pin
 

Hi Professor, and Thanks Bill for the referral! As for the small retaining pin, removal can range fromm a simple tap out with a ground down 1/16" punch, to removal by Laser!!! It is different every time, and it should be full length. but will most likely do the job even if compromised? If you want to, send me the toggle train and I will remove the old pin and instsll a new custom fit pin to cure the issue... Contact me at: gctomeks@msn.com
Let me know if you want to pursue a repair, and best to you, til....lat'r........:cheers:

1) Thanks to all for the help and responses.
.
2) G.T. I will be sending you an email after the Holiday
.
3) Merry Christmas and Happy Hanukah to all.

retaining pin!
 

Thanks Professor, Im looking forward to it.... best, til.....lat'r....GT