My Luger Project
 

I have a Mauser-Parabellum '06/73' "American Eagle" in 7.65 mm Parabellum with a 150 mm barrel. What I would like to do is switch out the 150 mm barrel with a 120 mm barrel like to one use on the Mauser-Parabellum '06/73' Bulgaria and Swiss Commemoratives. Now the easiest way to do this is to find a Mauser made spare barrel and do a remove and replace. Does anyone know if Mauser has spare parts for thier pistols? If I had the engineering drawing of the barrel I could fabricate one but I do not think Mauser would release that information to me.


One other thing, anyone know a Mauser Broomhandle expert. I have a Model 1930 Broomhandle that I can not rmove the magazine floor plate. No obivous damage but a real tight fit.


Well, thank you for your time and effort.

The Wizard

Re: My Luger Project
 

On the Broomhandle floorplate, push down on the button with some non maring (sic) tool, and pull foreward on plate. Works for me.


Lonnie

Re: My Luger Project
 

If Lonnie's method doesn't work on your Broomhandle, you might try Kyrie Ellis or Tom Heller. Thier email addresses should be in the Profile Section! Good Luck!

Re: My Luger Project
 

Wizard, On your broom, you may have to use I stong pin punch at a 45 degree angle, hitting floor plate forward at the same time that it depresses release button. Since I purchased all of Interarms Mauser Parabellum parts and know that Mauser doesn't have any barrel left in Germany, your best bet would be to find a nice bore M1906 LONG FRAME 120mm barrel for this project. All of the long frame ones that I have left are M1900, so the extractor cut would also have to be modified. Tom h.

Re: My Luger Project
 

Hi Wizard,


If you continue to have problems with the C96 e-mail me off line and I'll try and help....


Best regards,


Kyrie

Re: Barrel design
 

is not my cup of tea, although I do have acopy of all of the metric dimentions of the the 9X100mm military barrels as shown in the original 1913 Masstafeln zur PO8. I believe one of the members is offering the drawing of all PO8 parts from this book on CD at a reasonable price in the "links & resources" section. Tom h.

Re: My Luger Project
 

I sold a very good swiss 06/29 barrel to Hugh some time ago.

Check with him if he have it left in that case you can use thatone.


Regards HÃ?Â¥kan



http://www.vapensmedjan.com