Rear Conncecting Pin - Again

G.T. · 05-07-2001, 11:08 PM

Thanks Johnny! Can you imagine the amount of work it took to keep all there stuff straight! It sounds like thats what they would have to do, anneal, stamp, heat treat, etc...

Which brings me to my original question, do you think they did this with every new completed (Mauser military)pistol?, or, do you think they had a large selection of prenumbered pins that were installed at final assembly??? till...later...G.T.

05-07-2001, 11:08 PM	#37
G.T. Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: Chandler Arizona Posts: 3,542 Thanks: 1,342 Thanked 3,750 Times in 1,021 Posts	Re: BILL & GT ;^) Thanks Johnny! Can you imagine the amount of work it took to keep all there stuff straight! It sounds like thats what they would have to do, anneal, stamp, heat treat, etc... Which brings me to my original question, do you think they did this with every new completed (Mauser military)pistol?, or, do you think they had a large selection of prenumbered pins that were installed at final assembly??? till...later...G.T.