Luger Lubrication

[Sieger]

Originally Posted by The Virginian

One thing I like about CorrosionX is the guns clean up very easily with it. I fired my DWM Luger this weekend with Winchester White Box and it was a lead pipe cinch to clean afterwards. I only had one malufinction with it in about 100 rounds. It was a failure to fully extract and the next round in the magazine jammed under it. My brass key got it out and the gun functioned perfectly after that. I want to handload some hard cast lead 125 grain bullets to duplicate the performance. Any suggestions?

Hi:

Here is a good target load for you:

3.7 gr of Bullseye

OAL (Roundnose) 1.173 inches.

Try that one. For me, it is less than an inch at 25 yards (over a sandbag hold).

Sieger