Idea on repro grips !!!!

Herb · 02-15-2004, 01:45 PM

I have a set of solid aluminum grips that were apparently custom made. They have the initials R.E.S. on the left panel and Germany 1946 on the right one. They appear to have dents on both of them but looking closely it was a defect in the mold. They appear to have been poured rather than stamped as there are imperfections on both sides. They are about 1/4" of solid aluminum. These would no doubt last a lifetime or longer.

02-15-2004, 01:45 PM	#7
Herb User Join Date: Jun 2002 Location: Utah, in the land of the Sleeping Rainbow Posts: 1,457 Thanks: 0 Thanked 1 Time in 1 Post	I have a set of solid aluminum grips that were apparently custom made. They have the initials R.E.S. on the left panel and Germany 1946 on the right one. They appear to have dents on both of them but looking closely it was a defect in the mold. They appear to have been poured rather than stamped as there are imperfections on both sides. They are about 1/4" of solid aluminum. These would no doubt last a lifetime or longer. __________________ Utah, where gun control means a steady trigger pull