![]() |
my profile |
register |
faq |
search upload photo | donate | calendar |
|
|
#11 |
|
Lifer
Lifetime Forum Patron Join Date: Feb 2009
Location: ...on the 'ol Erie Canal...
Posts: 8,208
Thanks: 1,425
Thanked 4,474 Times in 2,343 Posts
|
I thought it was in this thread, but I don't see it...Anyway, someone commented on milling the bullets instead of drilling them...I couldn't do that with the drill fixture (holes are too deep) so I made a new fixture...
Two strips of 3/8" aluminum drilled & pinned and then top & bottom milled flat. Four 5/16" holes drilled with a .022" plastic strip as spacer between them, to allow for clamping. Fixture with four .110" dia M1 Carbine bullets clamped in position. I milled every .020" and weighed between cuts. The final measurement was .115" to get a ~86gr bullet. Final weighing before starting run. 86.2grs...Close enough! Comparison of 85gr Tokarev bullet, my shaved 86gr carbine bullet, and 110gr carbine bullet. I chamfered the bottom edge with a file to ease loading, but I think I will make a 'cap' that will press a round edge on the bottom... I also want to make a run of 95gr cut-down carbine bullets...
__________________
I like my coffee the way I like my women... ...Cold and bitter...
|
|
|
|
| Tags |
| blivet |
|
|