LugerForum Discussion Forums my profile | register | faq | search
upload photo | donate | calendar

Go Back   LugerForum Discussion Forums > General Discussion Forums > Repairs, Restoration & Refinishing

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 03-07-2013, 09:31 AM   #4
John Sabato
Lifer
Lifetime Forum
Patron
 
John Sabato's Avatar
 
Join Date: Jun 2002
Location: The Capital of the Free World
Posts: 10,157
Thanks: 3,003
Thanked 2,311 Times in 1,099 Posts
Default

Provided that the receiver is properly supported when you try to punch the pin out, no damage should occur.

Locate the left side of the receiver on a surface with a properly sized hole in it...

If you don't have such a surface, I would recommend that you purchase an inexpensive plastic kitchen cutting board and drill a hole in it. The plastic will provide sufficient support for the receiver and will not mar the surface during the removal.

Soak it in good penetrating oil for a few hours or even a day, and then Use a properly sized brass punch and a hammer, and as alanint has already said: It is driven out from the right to the left as you are looking at the back of the Luger...

Once you get it out, you can lightly polish the stubborn surface with 400-600 grit emery cloth to make sure it goes back in easy.
__________________
regards, -John S

"...We hold these truths to be self-evident that ALL men are created EQUAL and are endowed by their Creator with certain UNALIENABLE rights, and among these are life, LIBERTY, and the pursuit of happiness..."
John Sabato is offline   Reply With Quote
The following 2 members says Thank You to John Sabato for your post:
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 08:56 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
Copyright © 1998 - 2026, Lugerforum.com