LugerForum Discussion Forums my profile | register | faq | search
upload photo | donate | calendar

Go Back   LugerForum Discussion Forums > Luger Discussion Forums > Navy Lugers

Reply
Thread Tools Display Modes
Unread 03-19-2014, 10:19 AM   #1
erdikler
User
 
Join Date: Apr 2011
Posts: 14
Thanks: 1
Thanked 13 Times in 3 Posts
Default Help with 1906 Navy

Dear all,
I am considering to acquire this old sailor but I cannot be sure about its condition. The gun seems to have its original blue and in a good condition with the exeption a little to much pitted bore and almost total loss of blue on front grip strap. And also, the breech block seems to have been replaced or refinished since the proof mark (crown without M) faded or missing. Here are some pictures, apoligies for the low quality of the pictures but the these are the only ones I could get from the owner. Any opinion highly appreciated. Thanks in advance.
Attached Thumbnails
Click image for larger version

Name:	8.jpg
Views:	37
Size:	50.9 KB
ID:	40803  

Click image for larger version

Name:	4.jpg
Views:	40
Size:	53.1 KB
ID:	40804  

Click image for larger version

Name:	7.jpg
Views:	38
Size:	45.4 KB
ID:	40805  

Click image for larger version

Name:	9.jpg
Views:	35
Size:	28.6 KB
ID:	40806  

Click image for larger version

Name:	6.jpg
Views:	41
Size:	40.9 KB
ID:	40807  

Click image for larger version

Name:	5.jpg
Views:	33
Size:	46.2 KB
ID:	40808  

Click image for larger version

Name:	0.jpg
Views:	42
Size:	34.7 KB
ID:	40809  

Click image for larger version

Name:	1.jpg
Views:	44
Size:	31.9 KB
ID:	40810  

Click image for larger version

Name:	2.jpg
Views:	38
Size:	36.1 KB
ID:	40811  

Click image for larger version

Name:	3.jpg
Views:	39
Size:	37.9 KB
ID:	40812  

erdikler is offline   Reply With Quote
Unread 03-19-2014, 10:20 AM   #2
erdikler
User
 
Join Date: Apr 2011
Posts: 14
Thanks: 1
Thanked 13 Times in 3 Posts
Default

cont'd
Attached Thumbnails
Click image for larger version

Name:	11.jpg
Views:	35
Size:	34.0 KB
ID:	40813  

Click image for larger version

Name:	12.jpg
Views:	32
Size:	37.5 KB
ID:	40814  

erdikler is offline   Reply With Quote
Unread 03-19-2014, 10:32 AM   #3
mrerick
Super Moderator - Patron
LugerForum
Life Patron
 
mrerick's Avatar
 
Join Date: Dec 2009
Location: Eastern North Carolina, USA
Posts: 3,900
Thanks: 1,370
Thanked 3,094 Times in 1,503 Posts
Default

All these pictures have soft focus that obscures the detail of the markings and surfaces.

I'm not a Navy expert, but I doubt that they could help you much without proper detail visible.

While this one could be right as they come, these Navy variations are faked reasonably often. I would not buy one without being able to verify it with someone familiar with Navy details.

There is a Navy serial number list available. What is the SN? I see the end of it as "?077a" from what I can figure out in the pictures.

In your third from the last picture, there seems to be quite a bit of finish variation between the breech block and the DWM marked forward toggle.
__________________
Igitur si vis pacem, para bellum -
- Therefore if you want peace, prepare for war.
mrerick is offline   Reply With Quote
The following member says Thank You to mrerick for your post:
Unread 03-19-2014, 10:41 AM   #4
erdikler
User
 
Join Date: Apr 2011
Posts: 14
Thanks: 1
Thanked 13 Times in 3 Posts
Default

The serial number is 977 a and it has W.K. "Werft Kiel" stamped. You are right about the finish variation, which makes me think of a breech block replacement?
erdikler is offline   Reply With Quote
Unread 03-19-2014, 10:45 AM   #5
Norme
Always A
Lifetime Forum
Patron
 
Norme's Avatar
 
Join Date: Jul 2009
Location: Colorado
Posts: 2,414
Thanks: 224
Thanked 2,591 Times in 930 Posts
Default

Hi Eymen, Welcome to the forum. I don't see any obvious red flags in the photos provided, the finish does appear to be original. Before buying this gun, however, I advise you to insist on more and better photos. A clear, well lit shot of the left side of the breech block would be a start, in addition to the M firing proof it should have the last two digits of the serial number. Do all the other serial numbers match? I don't see the grip safety in the photos. I read the gun's serial number as 977a, is that correct?
Regards, Norm
P.S. What is the number below the W.K stamp?
Norme is offline   Reply With Quote
Unread 03-19-2014, 10:58 AM   #6
erdikler
User
 
Join Date: Apr 2011
Posts: 14
Thanks: 1
Thanked 13 Times in 3 Posts
Default

Dear Norm, Thank you very much. Yes, the serial number reads 977 a and the breech block has the last two digits of 77. Is it normal that the M proof is missing, though? All the numbers are matching other than the grips and magazine. The reason you cannot see the grip safety is that it has a broken spring and therefore it sits on the frame. I will ask the seller about the number below W.K and for a better picture of the breech block as you advised. Thanks again.
Best regards,

Eymen
erdikler is offline   Reply With Quote
Unread 03-19-2014, 11:00 AM   #7
Ron Wood
Moderator
2010 LugerForum
Patron
 
Ron Wood's Avatar
 
Join Date: Jun 2002
Location: Santa Teresa New Mexico just outside of the West Texas town of El Paso
Posts: 6,986
Thanks: 1,065
Thanked 5,088 Times in 1,674 Posts
Default

I am pretty sure I can see a grip safety in the first photo but it is flat against the grip. Either a broken safety spring or more likely incorrectly assembled.

Dang, I typed too slow again
__________________
If it's made after 1918...it's a reproduction
Ron Wood is offline   Reply With Quote
Unread 03-19-2014, 11:05 AM   #8
erdikler
User
 
Join Date: Apr 2011
Posts: 14
Thanks: 1
Thanked 13 Times in 3 Posts
Default

erdikler is offline   Reply With Quote
Unread 03-20-2014, 08:51 AM   #9
erdikler
User
 
Join Date: Apr 2011
Posts: 14
Thanks: 1
Thanked 13 Times in 3 Posts
Default

some more pictures.

Question is: is it normal that the proof mark on breech block is absent on a 1906 navy?

Best regards and that you all in advance
Attached Thumbnails
Click image for larger version

Name:	Resim 006.jpg
Views:	32
Size:	52.4 KB
ID:	40835  

Click image for larger version

Name:	Resim 041.jpg
Views:	33
Size:	42.7 KB
ID:	40836  

Click image for larger version

Name:	Resim 042.jpg
Views:	32
Size:	41.8 KB
ID:	40837  

Click image for larger version

Name:	Resim 044.jpg
Views:	30
Size:	47.8 KB
ID:	40838  

Click image for larger version

Name:	Resim 050.jpg
Views:	42
Size:	47.5 KB
ID:	40839  

erdikler is offline   Reply With Quote
Unread 03-20-2014, 09:25 AM   #10
Norme
Always A
Lifetime Forum
Patron
 
Norme's Avatar
 
Join Date: Jul 2009
Location: Colorado
Posts: 2,414
Thanks: 224
Thanked 2,591 Times in 930 Posts
Default

Hi Eymen, No, it's not normal. The Navy crown firing proof was stamped at three locations, the left sides of the barrel, receiver and breechblock, when the gun passed proof testing. If it's not on the breech block then it was either removed or the breech block is not original to the gun.
Regards, Norm
Norme is offline   Reply With Quote
Unread 03-20-2014, 11:13 AM   #11
erdikler
User
 
Join Date: Apr 2011
Posts: 14
Thanks: 1
Thanked 13 Times in 3 Posts
Default

Hi Norm, thanks for the info, your input proves that the gun was fired a lot, breaking the breech block, which in turn explains the avarage to poor state of the bore. Pity though, otherwise this piece would be a fine example if it were all matching. The asking price of approx. $ 5.000 is then way to much for a shooter.
Regards,
Eymen
erdikler is offline   Reply With Quote
Unread 03-20-2014, 08:59 PM   #12
CAP Black
User
 
CAP Black's Avatar
 
Join Date: Dec 2008
Location: Fairmont, WV Right here in Mountaineer country and God's country
Posts: 767
Thanks: 100
Thanked 168 Times in 96 Posts
Default

Yes, way too much; at least double fair price - IMHO. Hope the experts give you a more reliable response.
Jack
CAP Black is offline   Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 08:42 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright © 1998 - 2024, Lugerforum.com