1917 Erfurt

zampolit · 03-12-2010, 09:42 PM

Hey everyone, I just got this 1917 Erfurt from the Jan Still boards trader section. After doing a lot of research and all that I couldn't believe I stumbled upon basically the exact gun I wanted. It seems to be all matching, and I'm pretty sure that it has been refinished because of the buffing wear that it seems to have, though the discussion over at the other board has varied between how worn it really is. Anyway, I'd just like your opinions on my new gun if you have a chance. Also, the fireing pin doesn't release until hte trigger is pulled pretty hard, and I was wondering if the fact that the little rust colored piece under the doughnut on the left side being slightly bent could be the culprit in this case? The other discussion is at http://luger.gunboards.com/showthread.php?t=21917

03-12-2010, 09:42 PM	#1
zampolit User Join Date: Nov 2009 Posts: 10 Thanks: 0 Thanked 0 Times in 0 Posts	1917 Erfurt Hey everyone, I just got this 1917 Erfurt from the Jan Still boards trader section. After doing a lot of research and all that I couldn't believe I stumbled upon basically the exact gun I wanted. It seems to be all matching, and I'm pretty sure that it has been refinished because of the buffing wear that it seems to have, though the discussion over at the other board has varied between how worn it really is. Anyway, I'd just like your opinions on my new gun if you have a chance. Also, the fireing pin doesn't release until hte trigger is pulled pretty hard, and I was wondering if the fact that the little rust colored piece under the doughnut on the left side being slightly bent could be the culprit in this case? The other discussion is at http://luger.gunboards.com/showthread.php?t=21917 Attached Thumbnails