Jammed up Interarms PO-8 Mauser Luger

Herr Shoemaker · 11-29-2024, 10:42 PM

Hi Folks:
I went to the range today for the first firing of an Interarms Mauser PO-8 Luger. After inserting the magazine and attempting to chamber the first round, the toggle did not close properly, and it did not chamber the first round. Then the toggle would only pull about half way back open, and I could see that the first round was not chambered. But the magazine was jammed and would not drop out when I attempted to release it.
So I've got a jammed up Luger and one very frustrated owner. Can anyone tell me a SAFE WAY to unjam the pistol so I can get the magazine and bullets out of the gun so it can be shipped to a competent gunsmith who knows of this problem.
And any recommendations for competent Mauser Luger gunsmith would be appreciated. Thanks very much.

Sincerely, "Herr" Bert Shoemaker

gunbugs · 11-30-2024, 01:57 AM

Just press hard on the magazine release button. If you can get the magazine out, then everything else will function properly. I like to lock the gun open before I put a loaded mag in. Makes life easier. Or just load it with 5 or 6 rounds. Hand strength is important when operating semi auto pistols. An attribute that we lose as we get older...Sounds like you have the top round jammed against the bottom of the breechblock.

Kiwi · 11-30-2024, 09:13 AM

As Gunbugs said press really hard on the Magazine release, but also pull the magazine down with your other hand.

Fail to chamber
- be sure you are not trying to load 9mm into a 7.65.
Interarms Mausers come in both chamberings but they use the same magazines.

The first digits of the serial number indicate chamber 10.xxx is 7.65mm and 11.xxx is 9mm

ps. The Interarms Mausers are P-06 rather than P-08.

Mac Cat · 11-30-2024, 11:38 AM

Your magazine may be damaged - plan to substitute a different magazine.
Wiggle the magazine bottom while pressing harder on magazine release button.
Else, removing the grip panels might give you better access.

Herr Shoemaker · 11-30-2024, 11:56 AM

Many thanks to Mac Cat & Kiwi for your helpful information. I will proceed to see if I can get the jammed magazine out of the gun.

Bert Shoemaker

Jack moss · 11-30-2024, 03:34 PM

I am new and looking for information on 2 p-38 speerwerk world war 11 guns, 1 has 3 eagles stamped on , 1 has 1 eagle over 88 . I have collected for years but have lost track of the value of my guns as I have not been buying for years. I have had these 2 guns for apx 75 years.
can you tell me to whom I should go to find the value of these guns on the forum.

John moss

Doubs · 11-30-2024, 06:35 PM

Quote:

Originally Posted by Jack moss

I am new and looking for information on 2 p-38 speerwerk world war 11 guns, 1 has 3 eagles stamped on , 1 has 1 eagle over 88 . I have collected for years but have lost track of the value of my guns as I have not been buying for years. I have had these 2 guns for apx 75 years.
can you tell me to whom I should go to find the value of these guns on the forum.

John moss

John,

Start a new thread of your own. Piggybacking on an existing thread is unlikely to get you the answers you're seeking. Post clear, sharp detailed pictures of your P.38 pistols showing the complete guns and then pictures showing details. Members here are more than happy to help you evaluate your pistols.

Mac Cat · 11-30-2024, 08:32 PM

John, try the P.38 forum.
https://p38forum.com/forums/

11-29-2024, 10:42 PM	#1
Herr Shoemaker User Join Date: Dec 2011 Posts: 5 Thanks: 0 Thanked 15 Times in 2 Posts	Jammed up Interarms PO-8 Mauser Luger Hi Folks: I went to the range today for the first firing of an Interarms Mauser PO-8 Luger. After inserting the magazine and attempting to chamber the first round, the toggle did not close properly, and it did not chamber the first round. Then the toggle would only pull about half way back open, and I could see that the first round was not chambered. But the magazine was jammed and would not drop out when I attempted to release it. So I've got a jammed up Luger and one very frustrated owner. Can anyone tell me a SAFE WAY to unjam the pistol so I can get the magazine and bullets out of the gun so it can be shipped to a competent gunsmith who knows of this problem. And any recommendations for competent Mauser Luger gunsmith would be appreciated. Thanks very much. Sincerely, "Herr" Bert Shoemaker

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

11-30-2024, 01:57 AM	#2
gunbugs Lifetime Forum Patron Join Date: Sep 2013 Location: Fairbanks, Alaska. Home of the best moose. Posts: 661 Thanks: 367 Thanked 1,181 Times in 396 Posts	Just press hard on the magazine release button. If you can get the magazine out, then everything else will function properly. I like to lock the gun open before I put a loaded mag in. Makes life easier. Or just load it with 5 or 6 rounds. Hand strength is important when operating semi auto pistols. An attribute that we lose as we get older...Sounds like you have the top round jammed against the bottom of the breechblock.

11-30-2024, 09:13 AM	#3
Kiwi User Join Date: Mar 2019 Location: Wrong side of the Delaware river Posts: 313 Thanks: 222 Thanked 453 Times in 178 Posts	As Gunbugs said press really hard on the Magazine release, but also pull the magazine down with your other hand. Fail to chamber - be sure you are not trying to load 9mm into a 7.65. Interarms Mausers come in both chamberings but they use the same magazines. The first digits of the serial number indicate chamber 10.xxx is 7.65mm and 11.xxx is 9mm ps. The Interarms Mausers are P-06 rather than P-08.

11-30-2024, 11:38 AM	#4
Mac Cat Lifer Lifetime Forum Patron Join Date: Apr 2015 Location: Austin, Texas Posts: 738 Thanks: 2,109 Thanked 616 Times in 333 Posts	Your magazine may be damaged - plan to substitute a different magazine. Wiggle the magazine bottom while pressing harder on magazine release button. Else, removing the grip panels might give you better access.

11-30-2024, 11:56 AM	#5
Herr Shoemaker User Join Date: Dec 2011 Posts: 5 Thanks: 0 Thanked 15 Times in 2 Posts	Many thanks to Mac Cat & Kiwi for your helpful information. I will proceed to see if I can get the jammed magazine out of the gun. Bert Shoemaker

11-30-2024, 03:34 PM	#6
Jack moss New User Join Date: Nov 2024 Posts: 2 Thanks: 0 Thanked 0 Times in 0 Posts	I am new and looking for information on 2 p-38 speerwerk world war 11 guns, 1 has 3 eagles stamped on , 1 has 1 eagle over 88 . I have collected for years but have lost track of the value of my guns as I have not been buying for years. I have had these 2 guns for apx 75 years. can you tell me to whom I should go to find the value of these guns on the forum. John moss

11-30-2024, 08:32 PM	#8
Mac Cat Lifer Lifetime Forum Patron Join Date: Apr 2015 Location: Austin, Texas Posts: 738 Thanks: 2,109 Thanked 616 Times in 333 Posts	John, try the P.38 forum. https://p38forum.com/forums/