my profile |
register |
faq |
search upload photo | donate | calendar |
10-06-2024, 02:03 PM | #1 |
User
Join Date: Sep 2014
Posts: 69
Thanks: 0
Thanked 6 Times in 6 Posts
|
Installing Erma Extractor in Conversion kit
Have a Erma Green Box conversion kit. Trying to install the extractor, but despite many attempts, the extractor will not stay in place. I have used a small screw driver to hold back the detent and then released it to catch the top of the flat on the extractor. No good. The extractor fails to stay in place.
Any suggestion would be deeply appreciated. Thanks |
10-06-2024, 07:51 PM | #2 |
Twice a Lifer
Lifetime Forum Patron Join Date: Mar 2011
Location: Atop the highest hill in Schuyler County NY
Posts: 3,342
Thanks: 7,264
Thanked 2,569 Times in 1,363 Posts
|
The SE-08 extractors are difficult to install because their slot is not open, as in the SE-082. and you need to work thru the openings it has.
Note the "tail" on the bottom, rear of the extractor body. To achieve correct position, that tail needs to drop/click down into its vertical hole in the breech block. Once it's back as far as it can go in the breech block, use that little screwdriver to push down on the extractor body. I hope that screwdriver is brass. Unless you have three hands, push the setup against a piece of hardwood to get the extractor body back in far enough
__________________
"... Liberty is the seed and soil, the air and light, the dew and rain of progress, love and joy."-- Robert Greene Ingersoll 1894 |
The following 2 members says Thank You to ithacaartist for your post: |
10-08-2024, 12:17 PM | #3 |
User
Join Date: Sep 2014
Posts: 69
Thanks: 0
Thanked 6 Times in 6 Posts
|
Many thanks
Best |
The following member says Thank You to luger1 for your post: |
Thread Tools | |
Display Modes | |
|
|