Have any of you guys ever run into this little problem!!!

G.T. · 09-21-2002, 06:29 PM

I am just now completing my shooter... and believe me... I have seen a few strange problems while swapping parts, and checking fit & function! But, this is a new one for me... while trying several different trigger levers... I found one that actually fit/fell into the cutout for the sear bar, on the receiver, when fully depressing the trigger! Now I realize this would probably never be a problem when firing the pistol, it is quite disconcerning when checking the disconnector setup, and finding you cannot **** the pistol because the lever is impinging on the receiver!!! Locks it up tight....you can't pull it back at all.... have any of you other guys run into this!! ?? till...later...G.T. <img src="graemlins/jumper.gif" border="0" alt="[jumper]" /> <img src="graemlins/jumper.gif" border="0" alt="[jumper]" />

Hugh · 09-21-2002, 07:38 PM

GT, that's a new one on me! Usually I have the problem of them being to wide and not going far enough to trip the sear bar/firing pin contact. [img]confused.gif[/img]

John Sabato · 09-23-2002, 12:02 PM

I never heard of that problem before either GT... is it an original or a reproduction ... just out of curiosity...

09-21-2002, 06:29 PM	#1
G.T. Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: Chandler Arizona Posts: 3,507 Thanks: 1,318 Thanked 3,653 Times in 1,004 Posts	Have any of you guys ever run into this little problem!!! I am just now completing my shooter... and believe me... I have seen a few strange problems while swapping parts, and checking fit & function! But, this is a new one for me... while trying several different trigger levers... I found one that actually fit/fell into the cutout for the sear bar, on the receiver, when fully depressing the trigger! Now I realize this would probably never be a problem when firing the pistol, it is quite disconcerning when checking the disconnector setup, and finding you cannot **** the pistol because the lever is impinging on the receiver!!! Locks it up tight....you can't pull it back at all.... have any of you other guys run into this!! ?? till...later...G.T. <img src="graemlins/jumper.gif" border="0" alt="[jumper]" /> <img src="graemlins/jumper.gif" border="0" alt="[jumper]" />

09-21-2002, 07:38 PM	#2
Hugh RIP Join Date: Jun 2002 Location: Southeast Texas Swamp Posts: 2,460 Thanks: 2 Thanked 165 Times in 64 Posts	GT, that's a new one on me! Usually I have the problem of them being to wide and not going far enough to trip the sear bar/firing pin contact. [img]confused.gif[/img] __________________ *TRUMP FOR PREZ IN '20!*

09-23-2002, 12:02 PM	#3
John Sabato Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: The Capital of the Free World Posts: 10,154 Thanks: 3,003 Thanked 2,306 Times in 1,097 Posts	I never heard of that problem before either GT... is it an original or a reproduction ... just out of curiosity... __________________ regards, -John S "...We hold these truths to be self-evident that ALL men are created EQUAL *and are endowed by their Creator* with certain UNALIENABLE* rights, and among these are life, LIBERTY, and the pursuit of happiness..."*