Drum beat! Performance tips! - Page 2

milesc2 · 03-26-2018, 06:20 PM

Wanted to share an issue that I caused with my drum to save anybody else the trouble of learning the hard way.

Before I even attempted to load the drum I tore it down as per the instructions manual.

While reassembling I apparently over tightened the small screw at the base of the mag tube.
Went to the range with 25 rounds in the drum, the first 18 or so shot fine.
Then as the follower was starting to enter the mag tube it locked up.

Once I was home I was able to back the screw off a tad and the mag feeds all 32 rounds on a bench test X2.

Also I was able to feel the bind when loading. Based off my extremely limited experience, if the rounds are hard going in they will not be properly fed out.

So to summarize, don't over tighten the small screw at the base of the mag tube.

G.T. · 03-26-2018, 07:09 PM

Hi Miles, thanks for the report, and it is little tips and tricks that make the drums such a challenge! I will suggest that you again dissemble the drum and polish the whole length of the magazine tube with 320 W/D sand paper and a Scotch bright blending pad? Or 0000 steel wool! The slicker it is, the better it will work! polish the drum bowl / cup, both parts, and follower ends as well (need a fine polish grit? 600+), and re-grease! It should be slipper like a bearing anywhere the rounds run! BTW, I have up-graded the drum specs to use 124 grain bullets if available? I'm now testing American Eagle 124 9mm ball.. with excellent results so far... Best to all, til....lat'....GT

Lugerdoc · 03-27-2018, 12:25 PM

When will your next batch of modified drums make it to Numrich? TH

G.T. · 03-27-2018, 03:49 PM

Hi Thomas, 15 more units should just be there now? Another 15 units to send end of next week! (most likely arrive second week in April?...

.... ) best to all, til....lat'r....GT

cirelaw · 03-27-2018, 04:33 PM

Were either drum used on any other German firearm?

cirelaw · 03-27-2018, 05:08 PM

Who has always been there for me!

HerrKaiser · 03-27-2018, 06:04 PM

The trommelmagazin were able to be used in any Luger (in theory, as we have seen each one requires a bit of work to make one work) and they were also used by the Germans in their Bergmann MP 18 Sub-machinegun. 1 million of them were made but they are still incredibly sought after items.

cirelaw · 03-27-2018, 06:24 PM

Our Thompson had a 100 round 45cal~ I have one and can hardly pick it up loaded!

cirelaw · 03-27-2018, 06:29 PM

Awesome, Reminds me of our BAR~https://en.wikipedia.org/wiki/MP_18

03-26-2018, 07:09 PM	#22
G.T. Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: Chandler Arizona Posts: 3,507 Thanks: 1,318 Thanked 3,653 Times in 1,004 Posts	follower drag! Hi Miles, thanks for the report, and it is little tips and tricks that make the drums such a challenge! I will suggest that you again dissemble the drum and polish the whole length of the magazine tube with 320 W/D sand paper and a Scotch bright blending pad? Or 0000 steel wool! The slicker it is, the better it will work! polish the drum bowl / cup, both parts, and follower ends as well (need a fine polish grit? 600+), and re-grease! It should be slipper like a bearing anywhere the rounds run! BTW, I have up-graded the drum specs to use 124 grain bullets if available? I'm now testing American Eagle 124 9mm ball.. with excellent results so far... Best to all, til....lat'....GT

03-27-2018, 12:25 PM	#23
Lugerdoc Patron LugerForum Patron Join Date: Jun 2002 Location: POB 398 St.Charles,MO. 63302 Posts: 5,089 Thanks: 6 Thanked 736 Times in 483 Posts	When will your next batch of modified drums make it to Numrich? TH __________________ Tom Heller POB 398 ST.Charles, MO. 63302 Tel 636-447-3006 lugerdoc@charter.net

03-27-2018, 03:49 PM	#24
G.T. Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: Chandler Arizona Posts: 3,507 Thanks: 1,318 Thanked 3,653 Times in 1,004 Posts	Drum availability... Hi Thomas, 15 more units should just be there now? Another 15 units to send end of next week! (most likely arrive second week in April?....... ) best to all, til....lat'r....GT

03-27-2018, 05:08 PM	#26
cirelaw Lifer Lifetime Forum Patron Join Date: Dec 2003 Location: PORT ST LUCIE, FLORIDA Posts: 12,216 Thanks: 6,209 Thanked 4,133 Times in 2,173 Posts	For My Hero G.T. Who has always been there for me! Attached Thumbnails

03-27-2018, 06:04 PM	#27
HerrKaiser User Join Date: Feb 2018 Location: South Carolina Posts: 848 Thanks: 784 Thanked 861 Times in 411 Posts	The trommelmagazin were able to be used in any Luger (in theory, as we have seen each one requires a bit of work to make one work) and they were also used by the Germans in their Bergmann MP 18 Sub-machinegun. 1 million of them were made but they are still incredibly sought after items. __________________ -QM Looking for Mauser S/42 toggle train #22

03-26-2018, 06:20 PM	#21
milesc2 User Join Date: Dec 2016 Location: Kansas City Posts: 214 Thanks: 324 Thanked 249 Times in 66 Posts	Wanted to share an issue that I caused with my drum to save anybody else the trouble of learning the hard way. Before I even attempted to load the drum I tore it down as per the instructions manual. While reassembling I apparently over tightened the small screw at the base of the mag tube. Went to the range with 25 rounds in the drum, the first 18 or so shot fine. Then as the follower was starting to enter the mag tube it locked up. Once I was home I was able to back the screw off a tad and the mag feeds all 32 rounds on a bench test X2. Also I was able to feel the bind when loading. Based off my extremely limited experience, if the rounds are hard going in they will not be properly fed out. So to summarize, don't over tighten the small screw at the base of the mag tube.

03-27-2018, 04:33 PM	#25
cirelaw Lifer Lifetime Forum Patron Join Date: Dec 2003 Location: PORT ST LUCIE, FLORIDA Posts: 12,216 Thanks: 6,209 Thanked 4,133 Times in 2,173 Posts	Were either drum used on any other German firearm?

03-27-2018, 06:24 PM	#28
cirelaw Lifer Lifetime Forum Patron Join Date: Dec 2003 Location: PORT ST LUCIE, FLORIDA Posts: 12,216 Thanks: 6,209 Thanked 4,133 Times in 2,173 Posts	Our Thompson had a 100 round 45cal~ I have one and can hardly pick it up loaded!

03-27-2018, 06:29 PM	#29
cirelaw Lifer Lifetime Forum Patron Join Date: Dec 2003 Location: PORT ST LUCIE, FLORIDA Posts: 12,216 Thanks: 6,209 Thanked 4,133 Times in 2,173 Posts	Awesome, Reminds me of our BAR~https://en.wikipedia.org/wiki/MP_18 Attached Thumbnails