Barrel installation question

unitedcs · 07-13-2017, 10:49 AM

Hello, I'm curious what the procedure is to correctly install a barrel that does not line up when torqued in.
Thanks
Rick

Lugerdoc · 07-13-2017, 11:06 AM

Rick, I don't recommend changing luger barrels unless you have a proper LUGER reciever wrench and a hydralic vice. Suggest that you contact GT on this forum. TH

DonVoigt · 07-13-2017, 08:19 PM

Quote:

Originally Posted by unitedcs

Hello, I'm curious what the procedure is to correctly install a barrel that does not line up when torqued in.
Thanks
Rick

If it does not turn in far enough, the shoulder flange of the barrel is reduced in length and the face of the barrel also if need be.
The headspace may require adjustment to allow a round to chamber.

If it turns to far, it is a bigger problem. It can be fixed with a shim.
If really far out, the only good solution is a different barrel.

But what lugerdoc said is correct- don't unless you are set up for it.

07-13-2017, 10:49 AM	#1
unitedcs User Join Date: Feb 2016 Location: Land O Lakes, Florida Posts: 90 Thanks: 8 Thanked 30 Times in 15 Posts	Barrel installation question Hello, I'm curious what the procedure is to correctly install a barrel that does not line up when torqued in. Thanks Rick

07-13-2017, 11:06 AM	#2
Lugerdoc Patron LugerForum Patron Join Date: Jun 2002 Location: POB 398 St.Charles,MO. 63302 Posts: 5,089 Thanks: 6 Thanked 736 Times in 483 Posts	Rick, I don't recommend changing luger barrels unless you have a proper LUGER reciever wrench and a hydralic vice. Suggest that you contact GT on this forum. TH __________________ Tom Heller POB 398 ST.Charles, MO. 63302 Tel 636-447-3006 lugerdoc@charter.net