That little pin in the toggle...

Olle · 04-25-2013, 05:00 PM

Thanks, guys!

I actually got my number drill set out and gauged the hole last night. A 1.48mm bit slipped through and the next one wouldn't, so I figured that 1.5mm was the correct diameter. Seems like this was correct.

I made a new pin from a broken 1.5mm drill bit, the hole was a bit wallered out but it "felt right" as I tapped the pin through it. It should stay in place just fine, or as they say here in TN: "It ain't goin' nowhere".

And yes, those drawings are still on the wish list!

04-25-2013, 05:00 PM	#6
Olle User Join Date: Feb 2010 Location: Tennessee Posts: 1,149 Thanks: 159 Thanked 664 Times in 318 Posts	Thanks, guys! I actually got my number drill set out and gauged the hole last night. A 1.48mm bit slipped through and the next one wouldn't, so I figured that 1.5mm was the correct diameter. Seems like this was correct. I made a new pin from a broken 1.5mm drill bit, the hole was a bit wallered out but it "felt right" as I tapped the pin through it. It should stay in place just fine, or as they say here in TN: "It ain't goin' nowhere". And yes, those drawings are still on the wish list!