Gauging a dial caliper for reloading (9mm) - Page 2

rhuff · 12-24-2020, 04:36 PM

For my handloading I keep both a set of digital calipers and dial calipers handy on my bench. Either will get the job done. I don't own a plastic caliper, and likely will never purchase one. Maybe I am just too "old school"!!

JONABI · 12-24-2020, 09:45 PM

Thanks for the link. I'll have to check in that a little bit more.

JONABI · 12-24-2020, 09:39 PM

Thank you again. I've read on the subject a little and find it very inetresting. Eventually, I'll be relaoding for my 7 mm Rem Mag; which is why I bought a reloading press in the first place.

JONABI · 12-24-2020, 09:32 PM

Thanks for your knowledge and the link.

JONABI · 12-24-2020, 09:30 PM

Thank you for the suggestions, easier and good.

12-24-2020, 04:36 PM	#1
rhuff Patron LugerForum Patron Join Date: Mar 2011 Location: Az. Posts: 2,315 Thanks: 2,751 Thanked 999 Times in 734 Posts	For my handloading I keep both a set of digital calipers and dial calipers handy on my bench. Either will get the job done. I don't own a plastic caliper, and likely will never purchase one. Maybe I am just too "old school"!! __________________ Need DWM breechblock #21

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

12-24-2020, 09:45 PM	#2
JONABI User Join Date: Nov 2020 Location: Québec, Canada Posts: 36 Thanks: 57 Thanked 15 Times in 7 Posts	Thanks for the link. I'll have to check in that a little bit more.

12-24-2020, 09:39 PM	#3
JONABI User Join Date: Nov 2020 Location: Québec, Canada Posts: 36 Thanks: 57 Thanked 15 Times in 7 Posts	Thank you again. I've read on the subject a little and find it very inetresting. Eventually, I'll be relaoding for my 7 mm Rem Mag; which is why I bought a reloading press in the first place.

12-24-2020, 09:32 PM	#4
JONABI User Join Date: Nov 2020 Location: Québec, Canada Posts: 36 Thanks: 57 Thanked 15 Times in 7 Posts	Thanks for your knowledge and the link.

12-24-2020, 09:30 PM	#5
JONABI User Join Date: Nov 2020 Location: Québec, Canada Posts: 36 Thanks: 57 Thanked 15 Times in 7 Posts	Thank you for the suggestions, easier and good.