My 'New' 1902 Fat Barrel AE

Ron Wood · 01-02-2006, 11:22 AM

Norm,
The right grip is different between a 1900 and a 1906. The 1900 right grip has a wide rib that runs nearly the full length of the rear of the grip. It starts at the curved section at the bottom and runs up to within about 3/8" from the top. The 1906 has a short thin rib because of the change to a coil spring. It starts at the same place as a 1900 but only runs up as far as the web in the frame that supports the recoil lever assembly. So, a 1906 grip will work on a 1900 (or 1902) frame but a 1900 grip will not work on a 1906 frame.
Cheers,
Ron

P.S. Congrats on getting an '02. A landmark gun, and one that deserves to be in your collection.

01-02-2006, 11:22 AM	#6
Ron Wood Moderator 2010 LugerForum Patron Join Date: Jun 2002 Location: Santa Teresa New Mexico just outside of the West Texas town of El Paso Posts: 7,040 Thanks: 1,106 Thanked 5,256 Times in 1,724 Posts	Norm, The right grip is different between a 1900 and a 1906. The 1900 right grip has a wide rib that runs nearly the full length of the rear of the grip. It starts at the curved section at the bottom and runs up to within about 3/8" from the top. The 1906 has a short thin rib because of the change to a coil spring. It starts at the same place as a 1900 but only runs up as far as the web in the frame that supports the recoil lever assembly. So, a 1906 grip will work on a 1900 (or 1902) frame but a 1900 grip will not work on a 1906 frame. Cheers, Ron P.S. Congrats on getting an '02. A landmark gun, and one that deserves to be in your collection. __________________ If it's made after 1918...it's a reproduction

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode