LP-08 repo stock

lugerholsterrepair · 09-22-2005, 12:49 AM

MG, I have known Bill for quite a few years. He is an excellent machinist and a master craftsman. He replicated many items along the Luger line. I have never seen one of his stocks but I am positive he made them to original specs. I never knew if he made his stock irons and if so, if they were machined or cast. If you are considering one of his stocks you might want to ask that specific. I know that some time ago Bill had a stroke so I do not know the full extent of his condition at present. Last time I talked with him he was recovering nicely. Jerry Burney

09-22-2005, 12:49 AM	#8
lugerholsterrepair Moderator Lifetime Forum Patron Join Date: Jun 2002 Location: Arizona/Colorado Posts: 7,775 Thanks: 4,995 Thanked 3,134 Times in 1,439 Posts	MG, I have known Bill for quite a few years. He is an excellent machinist and a master craftsman. He replicated many items along the Luger line. I have never seen one of his stocks but I am positive he made them to original specs. I never knew if he made his stock irons and if so, if they were machined or cast. If you are considering one of his stocks you might want to ask that specific. I know that some time ago Bill had a stroke so I do not know the full extent of his condition at present. Last time I talked with him he was recovering nicely. Jerry Burney __________________ Jerry Burney 11491 S. Guadalupe Drive Yuma AZ 85367-6182 lugerholsterrepair@earthlink.net 928 342-7583 (CO & AZ) Year Round 719 207-3331 (cell) "For those who Fight For It, Life has a flavor the protected will never know."

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode