Specs for original P'08 ammo

Roadkill · 08-21-2005, 08:05 PM

Ill go to my toy room later and do some measurements, OAL was based on a Finnish round, I put it in the shell holder and lowered the seating die until it rested firmly on the bullet, I'm using 115g fmj with 5g of red dot and CCI small pistol primers but Winchester small pistol primers work as well. I use a mix of cases. The Luger was restored by Thor so the specs are as new. All springs were replaced, gun works best with a Mecgar magazine. Accuracy is very good, problem is that I have problems seeing that little thin front sight.

rk

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

08-21-2005, 08:05 PM	#8
Roadkill User Join Date: Jun 2002 Posts: 1,634 Thanks: 1 Thanked 28 Times in 17 Posts	Ill go to my toy room later and do some measurements, OAL was based on a Finnish round, I put it in the shell holder and lowered the seating die until it rested firmly on the bullet, I'm using 115g fmj with 5g of red dot and CCI small pistol primers but Winchester small pistol primers work as well. I use a mix of cases. The Luger was restored by Thor so the specs are as new. All springs were replaced, gun works best with a Mecgar magazine. Accuracy is very good, problem is that I have problems seeing that little thin front sight. rk