Another request on markings...

Roadkill · 06-21-2002, 09:08 PM

The sear safety bar is on the left side of the gun as it points away from you, just below the toggle. It has an elongated semi "Z" shaped bar with a small pin on each end that holds it in place. This prevents the sear from being released by pressure from the side, as Thor has repeatedly stated, a disassembled luger can be fired if a round is in the chamber with the bolt & toggle locked by pressure on the side. The sear safety prevents this, and it was on Police models. I took the sear bar out of mine and put it up so it couldn't be lost while firing. It would be difficult to replace and is not necessary to operate the gun. The safety still works. Sorry, I can't help with the markings, and welcome to the forum.

RK

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

06-21-2002, 09:08 PM	#2
Roadkill User Join Date: Jun 2002 Posts: 1,634 Thanks: 1 Thanked 28 Times in 17 Posts	The sear safety bar is on the left side of the gun as it points away from you, just below the toggle. It has an elongated semi "Z" shaped bar with a small pin on each end that holds it in place. This prevents the sear from being released by pressure from the side, as Thor has repeatedly stated, a disassembled luger can be fired if a round is in the chamber with the bolt & toggle locked by pressure on the side. The sear safety prevents this, and it was on Police models. I took the sear bar out of mine and put it up so it couldn't be lost while firing. It would be difficult to replace and is not necessary to operate the gun. The safety still works. Sorry, I can't help with the markings, and welcome to the forum. RK