Ejection Problem & Case Damage

Freischütz · 04-09-2003, 02:47 AM

I checked both the ejector and extractor.

The ejector is a replacement that moves freely, and the tip is undamaged.

I checked the extractor with a magnifying glass, and compared it to two other P.08s. I didn't see any damage. How strong should the spring be? This pistol's doesn't feel weak, but it's not as strong as my P.38. I can barely move that extractor with my finger.

My cartridges use moderate loads - 6.4gr of HS-6 behind a 122gr NEI truncated cast bullet. Following the recommendations of an article in the Cast Bullet Association's journal, I size the bullets to .357" diameter and seat them out to obtain an interference fit with the barrel's throat. Cartridge overall length is 29.74mm. The angled Luger magazine accepts these cartridges. They jam in the P.38.

Thanks again for the interesting suggestions!

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

04-09-2003, 02:47 AM	#1
Freischütz User Join Date: Jun 2002 Location: Eastern Washington Posts: 127 Thanks: 10 Thanked 26 Times in 19 Posts	I checked both the ejector and extractor. The ejector is a replacement that moves freely, and the tip is undamaged. I checked the extractor with a magnifying glass, and compared it to two other P.08s. I didn't see any damage. How strong should the spring be? This pistol's doesn't feel weak, but it's not as strong as my P.38. I can barely move that extractor with my finger. My cartridges use moderate loads - 6.4gr of HS-6 behind a 122gr NEI truncated cast bullet. Following the recommendations of an article in the Cast Bullet Association's journal, I size the bullets to .357" diameter and seat them out to obtain an interference fit with the barrel's throat. Cartridge overall length is 29.74mm. The angled Luger magazine accepts these cartridges. They jam in the P.38. Thanks again for the interesting suggestions!