Cast bullet ammo

Artsi · 09-27-2002, 02:52 PM

Lead bullets I treid were that .001 to .002 to over the bore dia. Despite that barrel got badly fouled in my P08.

I tried analythic approach and use slower burn rate powder. My attempt was to accelerate bullet over longer timeframe, rather than see it reach peak velocity in the first 1 inch after it has departed from case mouth.
That didn't work either. (I cannot remmeber anymore whether fouling was same or reduced).

Doubs - thanks for a good write up.

-Artsi

09-27-2002, 02:52 PM	#7
Artsi User Join Date: Sep 2002 Location: Finland Posts: 61 Thanks: 0 Thanked 0 Times in 0 Posts	Lead bullets I treid were that .001 to .002 to over the bore dia. Despite that barrel got badly fouled in my P08. I tried analythic approach and use slower burn rate powder. My attempt was to accelerate bullet over longer timeframe, rather than see it reach peak velocity in the first 1 inch after it has departed from case mouth. That didn't work either. (I cannot remmeber anymore whether fouling was same or reduced). Doubs - thanks for a good write up. -Artsi __________________ A golf course is a waste of perfectly good rifle range. (- someone in the net-)

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode