navy mags

Strider · 02-11-2004, 03:27 PM

OK folks, I am going to jump into this with both feet. I consider myself a novice when it comes to this so I ask for patience on this question.
Do the bottoms really need to have a concave surface on them? It would seem to me that these would have worked just as well with out the extra step involved in milling the bottoms out. Was this done purely for cosmetic reasons. Just something else to stir the pot here. By the way, this has been a great topic. Thanks.
Sid.

02-11-2004, 03:27 PM	#29
Strider User Join Date: Jun 2002 Location: Albuquerque, New Mexico Posts: 256 Thanks: 26 Thanked 0 Times in 0 Posts	OK folks, I am going to jump into this with both feet. I consider myself a novice when it comes to this so I ask for patience on this question. Do the bottoms really need to have a concave surface on them? It would seem to me that these would have worked just as well with out the extra step involved in milling the bottoms out. Was this done purely for cosmetic reasons. Just something else to stir the pot here. By the way, this has been a great topic. Thanks. Sid. __________________ Sid. Patience is a bitter plant, but it has sweet fruit. ~German Proverb If it is made before 1930 ..........It is a prototype.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode