OT - cleaning bores of target pistols

John D. · 05-31-2001, 11:37 AM

(First of all (and OT!!!!) - I'm through Chapter 2..!!! I think I'm partial so far to "byf" coded production - but then I think I need an example from each of teh manufacturers)

Great comments - but I've never noticed and impregnation. I'm not sure what the wood is (I'm not a wood expert by any means!) - but it appears to be very hard, but not hard enough to be "brittle" if you know what I mean - as it does flex" a bit.. Also - the rods I have are for Rifles and shotguns for what looks like about a .30 caliber. I still use the one he had for shotguns.

05-31-2001, 11:37 AM	#20
John D. Administrator & Site Owner LugerForum Patron Join Date: Jun 2002 Location: A Little NE of Somewhere... Posts: 2,651 Thanks: 478 Thanked 517 Times in 129 Posts	Hi Thor.. (First of all (and OT!!!!) - I'm through Chapter 2..!!! I think I'm partial so far to "byf" coded production - but then I think I need an example from each of teh manufacturers) Great comments - but I've never noticed and impregnation. I'm not sure what the wood is (I'm not a wood expert by any means!) - but it appears to be very hard, but not hard enough to be "brittle" if you know what I mean - as it does flex" a bit.. Also - the rods I have are for Rifles and shotguns for what looks like about a .30 caliber. I still use the one he had for shotguns.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode