Takedown lever moving

Thor · 11-03-2003, 07:06 PM

There are several differences in these post war American made Lugers over the German counterparts. The sear bar is BLIND pinned into the reciever (you would have to drill out the pin if you needed to take out the bar) The trigger lever is retained in the sideplate by a flush cut roll pin. The trigger lever is NOT BEVELed on the front edge like the originals so a reset of the trigger by allowing the trigger bar plunger to extend is "iffy". Some of these design changes seem to work. Some dont. Any chance someone can post an exploded part diagram for the AIMCO vintage Lugers?

11-03-2003, 07:06 PM	#10
Thor User Join Date: Jun 2002 Location: Rio Rancho, New Mexico Posts: 4,583 Thanks: 958 Thanked 971 Times in 277 Posts	There are several differences in these post war American made Lugers over the German counterparts. The sear bar is BLIND pinned into the reciever (you would have to drill out the pin if you needed to take out the bar) The trigger lever is retained in the sideplate by a flush cut roll pin. The trigger lever is NOT BEVELed on the front edge like the originals so a reset of the trigger by allowing the trigger bar plunger to extend is "iffy". Some of these design changes seem to work. Some dont. Any chance someone can post an exploded part diagram for the AIMCO vintage Lugers? __________________ Thor's Luger Clinic http://members.rennlist.com/lugerman/ Ted Green (Thor Yaller Boots) 725 Western Hills Dr SE, Rio Rancho, NM 87124 915-526-8925 Email thor340@aol.com ----------------------------------- John3:3 Jesus answered and said to him, "Most assuredly, I say to you, unless one is born again, he cannot see the kingdom of God."

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode