Chamber ridge

G.T. · 01-16-2003, 09:13 PM

Hello to all! This is just a WAG...but it is possible that the ring occurs when at some point in the manufacturing process, the chamber is prebored for stock removal... if done with an out of tolerance tool it could cut to deep for the finish reamer to clean it up... since it doesn't affect function...it was probably overlooked during the inspection process..."If it ain't in the plans, it ain't supposed to be there!" till...later....GT <img border="0" alt="[jumper]" title="" src="graemlins/jumper.gif" />

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

01-16-2003, 09:13 PM	#1
G.T. Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: Chandler Arizona Posts: 3,528 Thanks: 1,334 Thanked 3,711 Times in 1,014 Posts	Hello to all! This is just a WAG...but it is possible that the ring occurs when at some point in the manufacturing process, the chamber is prebored for stock removal... if done with an out of tolerance tool it could cut to deep for the finish reamer to clean it up... since it doesn't affect function...it was probably overlooked during the inspection process..."If it ain't in the plans, it ain't supposed to be there!" till...later....GT <img border="0" alt="[jumper]" title="" src="graemlins/jumper.gif" />