Halo

Ron Wood · 06-19-2002, 10:10 PM

Exactly correct Herb. The displaced metal from the stamping causes a raised area around the characters. The "halo" is a combination of the density of the metal and its effect on the bluing and the raised portion is also subject to more wear thus causing the lighter halo. However, some parts of some Lugers were finish sanded after stamping and before they were blued. A good example of this is the early Navy pieces. The receivers were sanded after stamping the proofs, but the barrels were proof stamped after bluing. Therefore the barrels will have the halo but the receivers will not.

06-19-2002, 10:10 PM	#3
Ron Wood Moderator 2010 LugerForum Patron Join Date: Jun 2002 Location: Santa Teresa New Mexico just outside of the West Texas town of El Paso Posts: 7,040 Thanks: 1,106 Thanked 5,257 Times in 1,724 Posts	Exactly correct Herb. The displaced metal from the stamping causes a raised area around the characters. The "halo" is a combination of the density of the metal and its effect on the bluing and the raised portion is also subject to more wear thus causing the lighter halo. However, some parts of some Lugers were finish sanded after stamping and before they were blued. A good example of this is the early Navy pieces. The receivers were sanded after stamping the proofs, but the barrels were proof stamped after bluing. Therefore the barrels will have the halo but the receivers will not. __________________ If it's made after 1918...it's a reproduction

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode