Rear Conncecting Pin - Again

G.T. · 05-07-2001, 11:08 PM

Thanks Johnny! Can you imagine the amount of work it took to keep all there stuff straight! It sounds like thats what they would have to do, anneal, stamp, heat treat, etc...

Which brings me to my original question, do you think they did this with every new completed (Mauser military)pistol?, or, do you think they had a large selection of prenumbered pins that were installed at final assembly??? till...later...G.T.

05-07-2001, 11:08 PM	#37
G.T. Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: Chandler Arizona Posts: 3,528 Thanks: 1,334 Thanked 3,711 Times in 1,014 Posts	Re: BILL & GT ;^) Thanks Johnny! Can you imagine the amount of work it took to keep all there stuff straight! It sounds like thats what they would have to do, anneal, stamp, heat treat, etc... Which brings me to my original question, do you think they did this with every new completed (Mauser military)pistol?, or, do you think they had a large selection of prenumbered pins that were installed at final assembly??? till...later...G.T.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode