Trigger Bar Assembly Removal

John Sabato · 11-06-2003, 05:04 PM

The spring holds the sear captive to the receiver...hold the sear bar stationary... and lift the hook on the spring (arrow "A") and slide it forward over the sear bar in the direction shown (arrow "B")... you can do this with a fingernail if it is not too flimsy or even a stiff piece of plastic that will fit in the hook if you are nervous about scratches... If you are careful, a small screwdriver will do the job nicely...

Once the spring is removed, the sear will come out without a problem.

11-06-2003, 05:04 PM	#2
John Sabato Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: The Capital of the Free World Posts: 10,156 Thanks: 3,003 Thanked 2,308 Times in 1,098 Posts	The spring holds the sear captive to the receiver...hold the sear bar stationary... and lift the hook on the spring (arrow "A") and slide it forward over the sear bar in the direction shown (arrow "B")... you can do this with a fingernail if it is not too flimsy or even a stiff piece of plastic that will fit in the hook if you are nervous about scratches... If you are careful, a small screwdriver will do the job nicely... Once the spring is removed, the sear will come out without a problem. __________________ regards, -John S "...We hold these truths to be self-evident that ALL men are created EQUAL *and are endowed by their Creator* with certain UNALIENABLE* rights, and among these are life, LIBERTY, and the pursuit of happiness..."*

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode